We are trying to verify the behavior of a supply-bootstrapped circuit using OPA828 in a TINA simulations. The purpose of the circuit is to reduce the common mode input impedance. However, we can see ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

I got stuck at using TI's "Solar_CLA.h". We have successfully initialized CLA and ran simple task which was perfectly working. In the next step, I followed the steps provided in the Solar Library ...

The revision history of the CLA_MATH_LIB_UG.pdf says ceil and floor functions were added in V4.03.02.00. I can't seem to find them or figure out how to call them. How to call these functions? Are they ...

Our BMS features two BQ76952 and a BQ34Z100-R2 on a shared I2C bus. When I connect the EV2400 device to calibrate the BQ76952 and open the bqStudio, it only detects the BQ34Z100-R2 not allowing me to ...

All 3D applications run failed with the message in our customized board. libEGL warning: MESA-LOADER: failed to open swrast: /usr/lib/dri/swrast_dri.so: cannot open ...

I hit a breakpoint in the EPWM interrupt, but the program doesn't stop in the interrupt. Does my program not enter the interrupt? I set the EPWM interrupt to change the value of cmpa and called the ...

My BQ76953EVM does not appear on my Windows 11 PC. However, it appears, loads the driver, and connects just fine on my Windows 10 PC. I have tried different USB ports and it doesn't appear in Device ...

so, according to the intel format definision, it indicates starting at adress of 000864B6, the hex image data is 76.... etc. The address 000864B6 is in the FLASH section D. Apparently this start ...

I am not able to flash my firmware to my MSP430FR6043 MCU using MSP FET. It was working fine previously but now suddenly it is not working as excepted. But the same MSP FET are working fine with other ...

Hello! This is not a strictly AWRL1432 post. I'm on a team of students working on a product for semi-truck safety. The student largely covering engineering responsibilities is quite busy both ...

After sending the calibration command, I put the ADS in short-circuit mode and performed some acquisitions to check the calibration. The measured values are not very ...